IT를 사랑하는 사람 RSS FEED

Select the Backup Options tab to reveal the following available options. You can select either Raw Mode, Zlib
Compression, or both.


.. Raw Mode . When selected, all partition information for a selected hard drive will be ignored, and a
“bit-by-bit” backup of the entire disk image will be performed. This bit-bybit form of data transfer will occur
during the restore of this backup as well, thereby eliminating the need to format the target drive.
 
.. Zlib Compression . Select this option to compress data on the VaultDR Client prior to transfer during backup. This will reduce overall network traffic during data transfer and also require less media space to accommodate the VaultDR backup. This option is particularly useful for partitions that contain a large amount of unused space, that would
otherwise need 1:1 space on the backup medium.


The Source  : www.bakbone.co.kr 

Add VaultDR Client

Name – The name of the desired VaultDR Client. NetVault will scan the network looking for any available
systems that can be added as a VaultDR Client, and reveal them for selection from this drop-down menu.

Port Number – The port used to invoke drdaemon (e.g., 15555). The default value is 10000. 



cf)

If you configured VaultDR to use a port other than the default “10000” as shown in The Add VaultDR Client dialog on page 65, you must exit from the VaultDR Daemon dialog and enter the new port number manually.

a. To exit the VaultDR Daemon dialog, press <Ctrl-C>.
b. At the command prompt, type the following command and press Enter: 
drdaemon -p port_number
where port_number is the port you specified.
Note: If you wish to relaunch VaultDR Daemon from the command prompt without changing the port number, type “drdaemon” and press Enter.


The Source  : www.bakbone.co.kr

APM Support Matrix 2008 12
VAULTDR SYS User's Guide